Sears 274.4279839 - Manual (Page 23)

Placing Channels in Memory (Autoprogramming)
Only channels 2-13 appear in the TV's memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up or down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section beloio.
Using Advanced Features
1. Place channels in
memory (autoprogram)
13
Controls Alarm Adjust Setup
Autooroaram
I
LabeL 13 clear 1
Channel Memory: 13 Stored
Cable/Air: Cable
VCR 1 Channel: 00
gontrol^^larmA^
Label 13 clear
Channel Memory: 13 Stored
Cable/Air: Cable
VCR 1 Channel: 00
A. Hook up an antenna, cable or
components before you begin
these steps or you will not be
able to add channels into
memory.
B. Press MENU repeatedly to
select the Setup Menu and
highlight Autoprogram. This
menu is white.
C. Press + to start the TV adding
all the channels into memory.
D. Wait until the TV has cycled
through all the channels and
returns to the original channel.
2. Add or delete channels
3. Press DONE to save the
setting
13
Controls Alarm Adjust Setup
Autoprogram ^
Label 13 clear
Channel Memory: 13 Stored
Cable/Air: Cable
VCR 1 Channel: 00
13
Controls Alarm Adjust
Autoprogram
Label 13
Setup
clear
Channel Memory: 13 Erased
Cable/Air: Cable
VCR 1 Channel: 00
A. Press MENU repeatedly to
select the Setup menu. This
menu is white.
B. Press CHANNEL down to
highlight Channel Memory.
C. Select the channel number you
want to add or delete with the
number buttons.
D. Press + to add or delete a
channel (you will see Stored on
the screen to add and Erased to
delete).
E. Repeat C and D for more
channels.
F. Press DONE to save the setting.
20