Sears 113.22643 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
3. Slide tension lever to the left to apply belt tension.
4. Tighten hex socket screw when bed is in desired
position,
5. Plug inthe power cord. Turn switch “ON” and imme
diately “OFF,” noting it the belt tends to slide off the
idler pulley or drive pulley. If it did not tend to slide off,
it is TRACKING properly.
6. If the sanding belt moves toward the disc, turn the
tracking knob clockwise 1/4 turn.
7. If the sanding belt moves away from the disc, turn the
tracking knob counterclockwise 1/4 turn.
8. Turn switch “ON” and immediately "OFF” again, not
ing belt movement. Readjust tracking knob if neces
sary.
Advertising