Sears 113.22643 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Locate washer 6.5x 17.8 x 1.6 and knob among loose
parts.
5. Position table support in corresponding holes on side
of base as shown. Make sure the 9.5mm diameter
index pin aiigns with upper hole.
6. Place washer on threaded shaft of knob and insert
through slot into threaded holes of base
WARNING: To avoid trapping the work or fingers
between the table and sanding surface, the table
edge should be a maximum of 1/16 inch from sand
ing surface.
7. Loosen the (3) hex head screws and adjust table.
i/i&mcH MAXIMUM
8. Use your Owner's Manual as a spacer. Place ten
pages of the Owner's Manual between the Disc and
the front edge of the table. Hold the table against the
manual and tighten the three (3) Hex Washer Head
screws.
OWNERS MANUAL
10 PAGES
WORK TABLE
SCALE LABEL TABLE LOCK
KNOB