Sears 113.22643 - Manual (Page 18)

;fâiiéie::OpèfâîiÔn'
Always sand dUtside curves on the left side of center on
the sanding disc as shown.
WARNING ; Applying the workpiece to the right side
of the disc could cause workpiece to fly up {kick­
back) and result in an injury.
SANDING SMALL END SURFACES ON
THE SANDING DISC
NOTE: Use of a Miter Gauge {optional accessory) is
recommended for this operation.
Always move the work across left side of center on the
sanding disc face as shown. - ; : v ^
MITER GAUGE
WARNiNG: Applying the workpiece tothe right side
of the disc first could cause workpiece to fly up
(kickback) and result in an injury.
WARNING; For your own safety, turn switch "OFF”
and remove plug from power source outlet before
adjusting your sander.
NOTE: Use a combination square to square the miter
gauge to the face of the disc (combination square must
be True”- See "Unpacking ' Tools Needed" section on
page 6 for checking this method). It it is not square,
loosen the miter gauge knob and move the miter gauge
slightly until^ it is square. VVithout moving the miter
gauge, tighten the knob securely.
Always position the workpiece to the left of center on
sanding disc with disc rotating counterclockwise as
shown.
The table may be tilted for beveled woili.
18