Sears 113.243311 - Manual (Page 10)

ossenibly
7, Install the small pulley ontothe motor shaft andtighten
the set screw in the pulley hub against the flat part of
the motor shaft.
SMALL (2-1/2" DIA.) MOTOR PULLEY
HERE WITH
MOTOR SHAFT
8. Push V-Be!t partly through belt guard enough to allow
belt to loop around the large pulley and push guard over
belt and pulley into position on guard support.
OPEN END
9. Push the lower section of the V-Belt through the^other
guard as in the previous step and loop V-Belt around
small pulley ori motor shaft.
10. Visually line up both pulleys and V-Belt until they are
perpendicular to the floor by sliding motor sideways as
needed.
11 - Press down hard on motor to put tension on the V-Belt
and tighten the motor mounting bolts at this time.
12. Check guard support before tightening guard support
screws to be sure it is centered around motor shaft end
will not rub against shaft when motor is running.
Tighten screws.
13. Push motor pulley belt guard into position onto guard
support.
10