Sears 113.243311 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HUB SET SCREW
4. Place the large pulley onto the drive wheel shaft and
insert the key into the keyway of the shaft and pulley.
Position pulley hub flush with end of shaft and tighten
set screw securely against key.
5. Place motor against the motor mounting bracket and
insert bolts through holes in motor base and then
through holes marked "X" in motor mounting bracket.
DO NOT TIGHTEN BOLTS AT THIS TIME. The "L”
bracket which holds the guard support must be slid
between the motor base and the motor mounting
bracket so motor must be loosely assembled to bracket
at this time.
Slide long leg of "L" bracket between motor base and
motor mounting bracket. Then sandwich the "L”
bracket between the guard support bracket and the
guard support and loosely fasten together with self
threading screws as shown, install clips onto belt
guard support.