Safety precautions – Sears 153.33645 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Safety Precautions

AWÂRNING

The water heater with draft hood installed must be prop­
erly vented to a chimney which terminates outdoors.

Never operate the water heater unless it is vented to the

outdoors and has adequate air supply to avoid risks of
improper operation, explosion or asphyxiation.

AWARNiNG

Minimum clearances between the water heater and com­
bustible construction are I" at the sides and rear, 4" at the

front, and 6” from the vent pipe. Clearance from the top of the

jacket is 18’’ on most models. Note that a lesser dimension may
be allowed on some models. Refer to the label on the water
heater adjacent to the gas control valve for all clearances.

A CAUTION

WATER HEATERS EVENTUALLY LEAK: installation

ot

the water heater must be accomplished in such a manner
that if the tank or any connections should leak, the flow of
water will not cause damage to the structure. When such
locations cannot be avoided, a suitable drain pan should
be installed under the water heater. Drain pans are avail­
able at your local Sears store. Such a drain pan must be

not greater than I

i/2

inches deep, have a minimum

length and width of at least

2

inches greater than the

water heater dimensions and must be piped to an ade­
quate drain. The pan must not restrict combustion air

flow. Under no circumstances is the manufacturer or
Sears to be held liable for any water damage in connec­
tion with this water heater.

AWARNiNG

Do not use this appliance if any part of it has been under
water. Immediately call a Sears Service Technician to
inspect the appliance and to replace the gas control or any
part of the burner system which has been under water.

AWARNING

HYDROGEN GAS: Hydrogen gas can be produced in a hot
water system that has not been used for a long period of
time (generally two weeks or more). Hydrogen gas is
extremely flammable and explosive. To prevent the possi­
bility of injury under these conditions, we recommend the

hot water faucet be opened for several minutes at the
kitchen sink before any electrical appliances which are

connected to the hot water system are used (such as a dis­
hwasher or washing machine). If hydrogen gas is present,

there will probably be an unusual sound similar to air

escaping through the pipe as the hot water faucet is
Opened. There must be no smoking or open flame near

the faucet at the time it is open.

AWARNING

INSULATING JACKETS: When installing an external

water heater insulation jacket on a gas water heater:

• DO NOT cover the temperature-pressure relief valve.
• DO NOT put insulation over any part of the top of the

gas water heater.

• DO NOT put insulation over the gas control valve or gas

control valve/burner cover, or any access areas to the
burner.

• DO NOT let insulation around the gas water heater to

get within 8 inches of the floor (air must get to the
burner).

• DO NOT cover or remove operating instructions, and

safety related warning labels and materials affixed to the
water heater.

Failure to heed this will result in the possibility of a fire or
explosion.

Advertising
This manual is related to the following products: