Service and adjustments, Your, Is equipped with a 12 – Sears 917.25559 User Manual
Page 22: Vehicles, Battery, Negative terminal
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove
steering wheel and reassemble per instructions in the
Assembly section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center.
,
TO REMOVE WHEEL FOR REPAIRS (See
Fig. 29)
•
Block up axle securely.
•
Remove axle cover, retaining ring and washers to allow
wheel removal (rear wheel contains a square key - Do
not lose).
•
Repair tire and reassemble.
•
On rear wheels only: align grooves in rear wheel hub
and axle. Insert square key.
•
Replace washers and snap retaining ring securely in
axle groove.
“ Replace axle cover.
{REAR WHEEL. ONLY)
FIG.
29
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 30)
A
CAUTION: Lead-acid batteries gener
ate explosive gases. Keep sparks, fíame
and smoking materials away from bat
teries. Always wear eye protection
when around batteries.
if your battery is too weak to start the engine, it should be
recharged. If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
YOUR
UNIT
IS EQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER
VEHICLES.
TO ATTACH JUMPER CABLES -
•
Connect each end of the RED cable to the POSITIVE
(+) terminal of each battery, taking care not to short
against chassis.
•
Connect one end of the BLACK cable to the NEGA
TIVE (-) terminal of fully charged battery.
•
Connect the other end of the BLACK cable to a good
CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
•
BLACK cable first from left side of chassis and fully
charged battery.
•
RED cable last from both batteries.
POSITIVE TERMINAL
NEGATIVE TERMINAL
CHASSIS •
CABLES
CHARGED
BATTERY
POSITIVE TERMINAL
NEGATIVE TERMINAL
FIG. 30
22