Sears 917.25559 - Manual (Page 7)

ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) 5/16" wrench
(2) 7/16" wrenches
(1) 1/2" wrench
Utility knife
(1) 9/16" wrench
Tire pressure gauge
Screwdriver
When right and left hand is mentioned in this manual, it
means when you are in the operating position {seated
behind the steering wheel).
TO REMOVE UNIT FROM CARTON
UMPACIC CARTON
• Remove all accessible loose parts and parts cartons
from carton (See page 6).
• Cut along dotted lines on carton, from top to bottom, ail
four corners of carton and lay panels flat.
• Check for any additional loose parts or cartons and
remove.
BEFORE ROLLING UNIT OFF SKID
ATTACH STEERING WHEEL (See Fig. 1)
Slide the steering bushing over the steering shaft.
Raise steering shaft forward until screw holes in dash
line up with steering bushing. Install two (2) sheet
metal screws and tighten securely.
Position steering boot over steering shaft.
Place tabs of steering boot over slots in dash and push
down to secure.
Slide steering wheel adapter onto upper steering shaft.
Position front wheels of the tractor so they are pointing
straight forward.
Position steering wheel so cross bars are horizontal
(left to right) and slide onto adapter.
Assemble large flat washer and 3/8-24 hex locknut and
tighten securely.
Snap insert into center of steering wheel.
Remove protective plastic from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY
STAPLES IN SKIDTHAT MAY PUNCTURE TIRES WHERE
UNIT IS TO ROLL OFF SKID,
(See Fig. 6)
• Raise attachment lift lever to its highest position.
• Release parking brake by depressing clutch/brake
pedal.
• Pull freewheel knob up to disengage transmission.
• Roll unit backwards off skid.
• Remove banding holding discharge guard up against
tractor.