Trouble shooting points, Trouble cause correction – Sears 536.886331 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLE SHOOTING POINTS
TROUBLE
CAUSE
CORRECTION
Dlfficull atarting
Defective spark plug
Water or dirt in fuel system
Replace defective plug.
Use carburetor bowl drain to flush and refill with fresh
fuel.
Engine runa erratically
Blocked fuel line or low on fuel
Clean fuel line; check fuel supply; add fresh
fuel (gasoiine/oil mixture if 2 cycle engine).
Engine alalls
Unit running on CHOKE
Set choke lever to RUN position.
Engine runa erratically;
Loaa of power
Water or dirt in fuel system
Use carburetor bowl drain to flush and refill with fresh
fuel.
Carburetor out of adjustment
Adjust carburetor.
Excessive vibration
Loose parts; damaged impeller
Stop engine immediately and disconnect spark plug wire
Tighten ail bolts and make all necessary repairs. If vibration
continues, have the unit serviced by a competent repairman.
Unit falls to propel
itself
Drive belt loose or damaged
Replace drive belt.
Incorrect adjustment of traction
drive cable
Adjust traction drive cable.
Worn or damaged friction wheel
Replace friction wheel.
Unit falls to
discharge snow
Auger drive belt loose or damaged
Adjust auger drive belt; replace if damaged.
Auger control cable not adjusted
correctly
Adjust auger control cable.
Shear bolt broken
Replace shear bolt
Discharge chute clogged
Stop engine immediately and disconnect spark plug wire
Clean discharge chute and inside of auger housing
Foreign object lodged in auger
Slop engine immediately and disconnect spark plug wire
Remove object from auger.
Headiight does not work
Loose wire connection
Tighten connection
Bulb burned out
Replace headlight bulb.