Sears 536.886331 - Manual (Page 7)

ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
1 ' Knife (to cut carton and plastic ties;
2 ' 1/2 inch wrenches (or adjustable wrenches)
2 - 9/16 inch wrenches (or adjustable wrenches)
2- 3/4 inch wrenches (or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
1 - Measuring tape or ruler
Figure 1 shows the snow thrower in the shipping position.
Figure 2 shows the snow thrower completely assembled.
Reference to the right and left hand side of the snow
thrower is from the operator’s position at the handle.
TO REMOVE SNOW THROWER
FROM CARTON (See FIG. 1)
• Remove packaging inserts located at tour corners of
carton.
• Locate and remove container of 5W30 oil found in
rear, right, carton insert.
• Cut all four corners of the carton from top to bottom
and lay the panels flat.
• Cut and discard plastic lies securing augers and
wheel axles to the pallet.
• Cut anddiscard plasticties and bagsthat secure crank
assembly and place assembly aside.
• Cut and discard plastic ties securing clutch cables to
lower handle.
• Remove plastic wrap from upper handle which was
used to protect clutch levers
O With the two 9/16" wrenches, loosen (but do not
remove) both bolts securing the upper and lower
handles by holding the inner nut on the inside of the
handle while turning the outside bolt counter-clock­
wise as shown in FIG. 4 A, in this section of the manual.
• Swing upper handle up into operating position as
shown in FIG. 2. Hold the inner nut and tighten me
outside bolt up against the handle.
FIG. 2
A CAUTION: IF YOU ARE REMOVING
SNOW FROM ANY GRAVELED OR UN­
EVEN SURFACE, RAISE THE FRONT OF
THESNOW THROWER BY MOVING THE
SKIDS DOWN. THIS WILL HELP TO PREVENT
STONES AND OTHER DEBRIS FROM BEING
PICKED UP AND THROWN BY THE AUGER.