A. getting ready, Attaching the bar and chain, Preparihg your saw for use – Sears 358.357182 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PREPARiHG YOUR SAW FOR USE
A. GETTING READY
1. READ YOUR OPERATOR'S MANUAL
CAREHJU.Y,
MsurOpecasx'sManualhasbmndeveiopedtohsIp
VQu prepare your saw for use and to understand its
safe operation. K ¡s unpottars that you react your
manual compiefety to become fentiliar with the saw
beisns you be^in assemtsiy.
2. HAVE THE FOLiewiNG AVAILABLE:
t. ^teetiwe gloves.
b. Approved, nteried fuel container
c. One gallon re^itr unleaded gasoline
d. 2>cycle. engine oil
& Btr and Chain Lubricant
f. Bar Adiustfng Toot provided with yoursaw. One
endofthe tйolser^«sas
a wrench; швопегсап
be
useaasascrewdrivef.
ATTACHING THE BAR AND CHAIN
I CAUTION:; Wear prateetive gloves wfienhandSng
oroptfsting your saw. Thediain is аПаф and eaneut
you even w^en ttisnotmoymg!
•
Ybur saw is equipped wi№ a ReducecMCIckäack
Guide Bar and a LmMCkdibacfcCtiain.
•
UsaoniyttwR*duead4Qei(baei(GutdaBarand
Low Klckfaacfc Ctiain apaeffied 1er your iMuun
saw medal wlian tipiaeing dtesa parts. See
«»PVvmCetlOftl»
A
warning
Do not start engine without guide bar and chain
compiately asaamblad. Qtherwiae, the clutch can
game off and serious injuryo»i residt
¡CAUTiON:tWaar pratiKdiyt gloves when han-
düng or openting your saw. The chain is sharp
and can cut you even when it is not movingl
1
. Remove the Allowing parts as shown in Figure B.
using me Bar AdjustiiTg TixA.
a. SarClamp Nut.
fa. RearSarCiampScrew.
c. Bar Clamp Houdng.
NÜ I1; Remove and cSscardlhe Plastic spaceron the
bar stud , if so equipped.
2. Turn the Adjusting Screw counterdockwise
to move the Adjusting Pin almost as far as
it will go to (he rear. Figures.
3. HoidchainwithcuttersiacingasshowninFigure?
{itiset).
4. Place chain over and behind the clutch drum,
onto the sprocket. Figure 7.
5. PtaoetfieGuideBaronmesawbySttingtheiaigeslat
in me Guide Bar over the Bar Slud. Figure &
& Rt the a^ushng pin Hio me 3($usdng prt hole bfiiow
the large slot; turn ms a|usting screw as rteeded
to position the adjusting pin. the large slot on
to the Bar Supports on aimer sids of me Bar SttkL
Figure i.
7. FftmechamintotheGuideS3rgrooves~»fiist.tho!Qp
groove, and then the botlom groove.
.
Figure?
RgureS