The rear panel – Tascam 122MKIII User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
□ The Rear Panel
28
29
30
33
28. INPUT XLR-type jacks
: Accept +4 dBm balanced
signals. Pin assignment : Pin 1 is shield (ground). Pin 2 is
Hot (+), and Pin 3 is Cold (-).
29. INPUT UNBAL/BAL switch
: Selects either the
XLR-type or RCA input jacks.
30.
OUTPUT XLR-type Jacks
: Transmit +4 dBm
balanced signals to your mixer, monitor amp, etc. Pin
assignment: Pin 1 is shield (ground). Pin 2 is Hot (+), and
Pin 3 is Cold (-).
31.
OUTPUT RCA jacks :
Transmit -10 dBV
unbalanced signals.
32. INPUT RCA jacks :
Accept -10 dBV unbalanced
signals.
33.
Blank Panel (except 122 MKIII)
: Space for
mounting an optional balanced amp kit (LA-112).
When the LA-112 is installed, you who are using the
112R MKII/112 MKII will have access to the INPUT
XLR-type jacks (#28), the INPUT UNBAL/BAL switch
(#29) and the OUTPUT XLR-type jacks (#30) as with the
122 MKHI.
34. REMOTE CONTROL connector
: This 25-pin D-
sub connector is for controlling the transport from the
optional remote RC-112R (for 112R MKII) or RC-134 (for
122 MKIII and 112 MKII), or for fader start from a mixer.
A 25-pin connector (Part No. 53363571-00) and its jacket
(Part No. 5336358100) are optionally available.
Fader start (122 MKIII and 112 MKII only) : Pins 22 and
24 are assigned for this function. The transport will toggle
Play and Pause, as depicted.
8