Compaq 3000 - Manual (Page 34)

EK–SMCPQ–UG. C01 2–1
2
RAID Array Controller
This chapter describes the major features and characteristics of the RAID array control-
ler in the controller shelf.
2.1 Controller Overview
The RAID Array controller provides high performance, high-availability access
to SCSI disk array subsystems along a wide UltraSCSI bus. With a modular
hardware design and an intuitive configuration utility, the controller is designed
to meet a wide range of storage needs.
The controller consists of a single 5 1/2” x 8” circuit board mounted in a subas-
sembly. The package consists of the controller board, a 300-pin connector, me-
chanical insertion assists, and a front panel LED/reset switch interface. All sig-
nals to the controller are routed through the backplane connector.
Figure 2–1 shows a simplified block diagram of the controller and its interfaces
to the major components in the RAID Array 3000 . The unit is configured with
two Ultra-Wide, differential, SCSI host channels capable of transferring data to
and from the host at rates up to 40 MB/s. The host SCSI IDs are configurable via
the Host Parameters and can support 32 deep tagged queuing. The controller is
also configured with two Ultra-Wide, single-ended, SCSI disk channels capable
of transferring data to and from the disk drives at rates up to 40 MB/s. Each
channel can support up to 12 drives.
The controller has two SIMM connectors. The connectors form a mirrored pair
when the controllers are configured in a redundant controller configuration; oth-
erwise they are fully accessible by the controller. In a redundant controller setup,
both controllers must have identical cache configurations and the total usable
cache (per controller) will be half the amount installed. Thus, in a single con-
troller setup the maximum usable cache is 128 MB while a redundant setup has a
maximum usable cache of 64 MB (per controller).