Conair RB70 - Manual (Page 4)

GROUNDING INSTRUCTIONS
For your protection, Waring ® Blendors are equipped
with a 3-conductor cordset that has a molded 3-prong
grounding-type plug, and should be used in combination
with a properly connected grounding-type outlet as shown
in Figure A. If a grounding-type outlet is not available, an
adapter, shown in Figure B, may be obtained so that a
2-slot wall outlet can be used with a 3-prong plug. As in
Figure C, the adapter must be grounded by attaching its
grounding lug under the screw of the outlet cover plate.
CAUTION:
Before using an adapter, it must be determined
that the outlet cover plate screw is properly grounded. If in
doubt, consult a licensed electrician. Never use an adapter
unless you are sure it is properly grounded.
Note: Use of an adapter is not permitted in Canada.
IMPORTANT: HOT BLENDING INSTRUCTIONS
To minimize possibility of scalding when blending hot
ingredients, the following precautions and procedures must
be observed:
1. Limit amount of material blended to one cup (8 oz.).
2. Completely remove the lid insert of the two-piece
container lid before starting motor. (This will allow
venting of the rapidly heated and expanding air
present inside container when blender is running.)
3. Start blending on low speed.
4. While blender is running, up to 1 1 ⁄
2
cups (12 oz.) of
additional liquid can be added. Pour liquid slowly
through the opening in the lid.
3