Casablanca Fan Company Casablanca Brescia Gallery Edition - Manual (Page 10)

9
B
RESCIA (G
ALLERY
E
DITION
)
Step 17. Carefully slide the glass into the light kit as
shown.
LIGHT KIT GLASS
GLASS
LIGHT FIXTURE GLASS INSTALLATION
Step 18. Lift the light fixture to the switch housing, run-
ning the cap screws through the key holes.
ATTACH LIGHT KIT TO FAN
CAUTION! Make sure you feed extra wire from
the light fixture through the center hole of
the switch housing to avoid pinched wires.
Turn the light fixture left (counter-clockwise) to engage
the screws in the key holes.
FAN CONTROLS
You may now proceed to
the fan control system for
your fan.
TIGHTEN SCREWS, INSTALL BULBS & PLACE GLASS
Step 19. Carefully push the glass aside
to access the cap screws. Ensure that
the screws are properly engaged in the
keyholes and tighten firmly by hand.
Step 20. Install the two 100 Watt bulbs.
Step 21. Carefully slide the glass down
into place.
CAP
SCREWS
100W
A15
BULBS
GLASS
For Inteli•Touch (wall control) operation,
please see the instructions on Page 1
1.
For Comfort•Touch models (remote control),
please see the directions on Page 1
5.
R
R
CAUTION! TO REDUCE THE RISK
OF FIRE USE MAX TWO 100W A15
INCANDESCENT LIGHT BULBS.