Casablanca Fan Company Casablanca Brescia Gallery Edition - Manual (Page 7)

6
Step 9. Attach the blades to the blade
holders by first pressing the blade badge
into the blade, then installing the blade
holder using the four blade screws and
flat washers provided for each blade.
Using the screwdriver, tighten securely
by hand only.
Repeat for each blade assembly.
BLADE SCREW
(4 PER BLADE)
BLADE
BLADE
HOLDER
BLADE INSTALLATION
BLADE SCREW
(4 PER BLADE)
BLADE & BLADE HOLDER HARDWARE
BLADE
HOLDER
BLADE HOLDER
SCREW
(2 PER BLADE)
Step 8. To reach the blade holder mounting
holes in the fan motor the dummy switch
housing must be removed.
Take out the two 5-32 X
9 /
32
” screws secur-
ing the dummy switch housing and remove.
Set the two (2) screws aside for the mo-
ment, they will be used in Step 12 to install
the switch housing after the blades are in-
stalled.
The dummy switch housing is used only when
shipping the fan.
INSTALLING THE BLADE/BLADE HOLDER TO FAN MOTOR
PREPARATION
DUMMY
SWITCH
HOUSING
Note: Save these two screws–they
will be used in Step 12.
BLADE
BADGE