Crimestopper Security Products CS-2016DPII-FM - Manual (Page 20)

SETTING THE CLOCK (2-WAY- LCD REMOTE)
1. Press and hold all 4 buttons of remote control for approximately 3 seconds until remote beeps.
2. The minute display will begin flashing. Use the lock and unlock button to change the minute up or down
to the correct time and then press button #3 (Trunk) to set the minute value.
3. The hour display should begin flashing. Use the lock and unlock button to change the hour up or down
to the correct am or pm hour.
4. Once the correct time is displayed, wait 6 seconds, the remote will beep twice and the time of day is set.
REMOTE START DIAGNOSTICS
If the system flashes the parking lights one to three times and doesn’t attempt remote, it means the following:
1 Parking Light Flash = Problem with Brake Switch. There could be a problem with a bad brake light. Many
dual filament light bulbs connect the brake and park lights together when bulb goes bad. Check all brake lights
work properly.
2 Parking Light Flashes = Problem with Hood Switch. Make sure hood is closed or that the Blue hood pin
wire is not shorted to Ground.
3 Parking Light Flashes = Valet Service Mode. Check the Alarm Status LED light and if it is on Solid Blue
(with doors closed) then the system is in Valet Mode. To exit Valet Mode, turn the Ignition on, press and hold
Valet Button for about 5 seconds until LED goes out. Unit is now out of Valet Mode and should perform a
remote start.
Crimestopper Security Products Inc.
1770 So. Tapo Street
Simi Valley, CA 93063
(800) 998-6880
www.crimestopper.com
[email protected]
©2007 Crimestopper Security Products
ONLINE TECHNICAL SUPPORT
www.crimestopper.com