Crimestopper Security Products CS-2016DPII-FM - Manual (Page 8)

8
PM
VALET MODE
PM
VALET LOCK
PM
VALET UNLOCK
OPERATING INSTRUCTIONS - ALARM
Emergency Override (Disarm)
If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to
disarm the system manually. Open the door with the key [alarm will sound], turn the ignition on, and press the
override/program button for about 5 seconds. The Alarm will disarm and allow you to use the vehicle until you
can repair/replace the remote. Valet mode also prevents Passive Arming.
Valet Mode (Enter manually or using the remote)
To disable Alarm and Remote Engine Starting for vehicle servicing or otherwise, turn the ignition on and press
the override/program button [about 5-7 seconds] until you hear (3) siren chirps and the LED turns on solid.
Repeat the process to exit VALET mode. To enter / exit valet via the remote: disarm system, then press and
hold both buttons #1 (Lock) and Button #2 (unlock) together for about 3 seconds until 3 chirps are heard.
Repeat this step to exit via the remote transmitter. Lock/Unlock and AUX features will still operate in when in
VALET mode however remote start and alarm functions are inhibited.
Valet Park Mode (Using the remote transmitter only)
Note: Valet Park mode is only accessible when using the remote transmitter. Valet park mode allows you to
turn over the vehicle to a valet allowing access to drive/lock/unlock your vehicle, but alarm will trigger if the
trunk is opened. To activate Valet Park: disarm system, then press and hold both buttons #1 (Lock) and
Button #2 (unlock) together for about 3 seconds. 3 chirps will be heard first when unit goes into regular Valet
Then press and hold both buttons again, you will hear 2 more chirps. LED will always flash slowly when in
Valet Park even when the Ignition is turned on (or driving vehicle). Repeat step above to exit Valet Park
mode.