Crimestopper Security Products CS-2016DPII-FM - Manual (Page 9)

9
PM
IGN
CONFIRM REMOTE
START REQUEST
PM
IGN
(<<<< MOVING <<<<<)
SUCCESFUL START
REMOTE ENGINE CONTROL
REMOTE ENGINE STARTING - SUCCESSFUL START
1) Press remote start button on the remote transmitter. System will chirp 3 times for audible confirmation.
(Chirps can be programmed on or off-See installation manual.)
2) Parking lights flash once, then turn on solid, Ignition/Accessory circuits turn on.
3) After a few seconds, Starter Motor engages, Parking lights and Accessory circuits turn off while cranking.
4) Engine Starts and Runs. Parking Lights and Accessory turn back on, Doors Lock.
5) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can
be turned off with remote transmitter.
REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM:
DOUBLE BUTTON PRESS FOR REMOTE START and TRUNK RELEASE
This option will allow you to change whether the Remote starter and Trunk release activate by a single press
or a double button press. Check with your installer or follow programming option instructions in the installation
manual.
REMOTE ENGINE STARTING – LCD PAGER-REMOTE:
When requesting a remote start the LCD pager remote will
confirm with an Ignition Icon along with 4 beeps. Once the
vehicle has successfully started the remote will confirm
back with 2 vibrations, a moving vehicle Icon, and 4
beeps.
AFTER
IGN
3
STARTER
THEN
FLASH 1X
SOLID
SOLID
SEC.
START