Evenflo Symphony 65 - Manual (Page 33)

Installing Child Restraint Forward-facing
in Aircraft
62 63
General
• DO NOT lubricate or immerse in water the SureLatch con-
nectors, the buckle, or any other part of this child restraint,
unless rinsing is permitted, as stated on the back of the
buckle for your restraint.
• Plastic and metal parts may be wiped clean with mild
soap and water and dried with a soft cloth.
Do not use abrasive cleaners or solvents.
• Take care not to damage any labels.
• The harness can be wiped clean with mild soap and
water. Allow harness to air dry.
• Machine wash the seat pad separately in cold water,
delicate cycle. Tumble dry 10 to 15 minutes on low
heat.
• NEVER use child restraint without the seat pad.
• To protect the child restraint from damage caused by
weather, rodents, and other elements common to
garages, the outdoors, and other storage locations,
remove the seat pad and thoroughly clean the restraint
and pad prior to storage. Take care to clean in the areas
where crumbs and other debris tend to accumulate.
Care and Cleaning
• To help protect the
vehicle upholstery, place a
towel beneath and behind
the child restraint.
T
ip
! T
ip
!
Proper Disposal of This Child Restraint
At the end of this child restraint’s useful life, Evenflo
encourages you to dispose of it properly. Most of the
components in this child restraint are recyclable.
1. Remove all fabric and padding.
2. Remove all screws and disassemble the restraint.
3. Recycle all plastic/foam parts and discard the rest.
If your local recycling center won’t accept the padding,
you may dispose of it in the landfill.
Note: Evenflo uses recycled materials in the
manufacturing process whenever possible but never
for components that are critical for safety.
To prevent injury due to hidden damage, lost instructions,
outdated technology, etc., discontinue use of this restraint
after eight years or if it has been involved in a crash.
buckle storag e
Forward-facing
Belt Path
4. Check your work.
With your hand holding the seat shell at the forward-
facing belt path, as shown, try to move the child
restraint from side to side. Then, holding the seat
shell at each forward-facing belt path, try to move
the restraint from front to back.
If you can move the child restraint more than 25
mm (1 inch) from side to side or front to back at
the belt path, the aircraft seat belt is not tight
enough, and you
MUST install again until the air-
craft seat belt is tight.