Nespresso Citiz & Co EF 488 User Manual
Page 104
Advertising
Citiz service manual
104
R E P A I R S
8.7.6 Replacing thermoblock with NTC sensor and fine
wire fuse(s)
A defect thermoblock can only be replaced with an assembly consisting of
thermoblock, prewired with NTC temperature sensor, fine wire fuse(s) and ground
wire (only if required),
thermoblock support.
•
Use Torx screwdriver TX10 to loosen screw (40).
•
Release 3 latches and pull out support with thermoblock assembly (15).
Depending on
national regulations,
one or two fine wire
fuses are mounted on the
thermoblock (see “Wiring
diagrams” on page 118
and following).
Do not stress NTC
cable when remov
ing support.
Advertising
This manual is related to the following products: