Assembly checkpoints – Nespresso Citiz & Co EF 488 User Manual
Page 117
Citiz service manual
117
R E P A I R S
•
Remove first
NTC connector from electronic control board,
connector cable from flow meter,
electronic lid (43),
faston receptacles from electronic control board.
•
Insert tip of screwdriver between chassis (1) and protective case of electronic control
board (42) to release latches. Then pull out assembly.
Assembly checkpoints
•
The left and right button prints (42) are marked with "L" or "R" for easy identification.
•
After assembly check the plug arrangement of the mainboard (see “Wiring
diagrams” on page 118 and following).
•
Lay connection wires to button prints in brackets and cable guides like shown.
For installing and
connecting a new
electronic control
board, the service techni
cian must be earthed with
a grounding band.