Champion juicer G5-NG-853-S - Manual (Page 4)

3
1. Read all assembly and operating
instructions prior to use. Incorrect assembly
and/or operation of the juicer can cause
difficulty in operating the juicer safely
and/or efficiently.
2. To protect against electrical hazards,
do not immerse motor or base in water or
other liquid.
3. The Champion 2000+ Juicer is not
designed to be operated by children.
4. Unplug juicer when not in use and
before cleaning.
5. Avoid contacting moving parts.
6. Do not operate the juicer with a damaged
cord set or after the juicer has been dropped
or damaged in any other manner.
7. The use of accessories not recommended
by Plastaket Manufacturing Co. may
cause hazards.
8. Outdoor use of the Champion 2000+
Juicer is not recommended.
9. Cutter blades are sharp. Handle carefully.
10. Never feed food by hand. Always use
the tamper.
11. Be sure to turn switch to “OFF” position
after each use of your juicer. Make sure the
motor stops completely before disassembling.
12. Do not put your fingers or other objects
into the juicer openings while it is in oper-
ation. If food becomes lodged in the feeding
chamber, use another piece of vegetable
or fruit to push it down. When this method
is not possible, turn the motor off, unplug
juicer cord and disassemble juicer to remove
the remaining food.
13. Do not let the cord hang over edge of
a table or counter or touch hot surfaces.
14. Do not place the juicer or parts near
any hot surface.
15. Save these instructions.
When using the Champion 2000+ Juicer, basic safety precautions should always be
practiced including the following:
Important Safeguards
Damage
OR
Breakage
IN
Transit
Every Champion 2000+ Juicer
is insured against shipping damage
or breakage. Inspect your juicer
carefully before initial operation.
In the event of damage or
breakage, contact your place of
purchase and the shipper for fur-
ther instructions.
Do not return the juicer or any
components to Plastaket
Manufacturing Company without
prior notification to the shipper
or Plastaket Manufacturing
Company (209)369-4638.
Some models shipped outside the
U.S. may need wiring changes to
adapt to local electrical standards.
Contact Plastaket Manufacturing
Company for information at
[email protected].