CBM America CBM-262 - Manual (Page 51)

6
Chapter 6 Interfaces
42
NO. Signal Name Function
1 FG Safety ground.
2 DRAWERI Drawer 1 drive signal.
3 DRSW Drawer switch input.
4 VDR Drawer drive power supply.
5 DRAWER2 Drawer 2 drive signal.
6 GND Common ground in the circuit.
6 1
Connector Connection Diagram
Connector Used: TM5RJ3-66 (Hirose)
Compatible Connector: Compatible with TM3P-66P (Hirose)
• No signals are output during printing.
• Both drawers 1 and 2 cannot be driven simultaneously.
• Use a 36 ohm or higher drawer solenoid. (Be careful not to let the output current
exceed 0.8A. If the output current exceeds 0.8 A, results cannot be guaranteed.)
• The drawer kick connector is not the type used for connections to telephone lines. Do
not connect to any device other than a solenoid.