CBM America CBM-262 User Manual
Page 85
7
Chapter 7
Print Control Codes
76
(35) Selecting the setting sheet (ESC c 1 n)
Code: [1B] h + [63] h + [31] h + n
* (1
n
3) Data are expressed in Hex code.
Selects the sheet which is the object of line feed settings set by ESC 2 and ESC 3.
•
Each bit of n is as shown in the following table.
•
If the value of n deviates from the definition range, this command is disregarded.
•
The initial value is “n = 3”.
(36) Selecting an effective paper end sensor for outputting the
paper end signal (ESC c 3 n)
Code: [1B] h + [63] h + [33] h + n
* (0
n
FF) Data are expressed in Hex code.
Selects which state of which sensor for outputting to the Centronics parallel interface
PE signal.
•
The initial value is “n = 3”.
[Note]
This is valid for the parallel interface only.
Bit
Function
Value
0
1
0
Journal
Disable
Enable
1
Receipt
Disable
Enable
2
Not defined
3
Not defined
4
Not defined
5
Not defined
6
Not defined
7
Not defined
Bit
Function
Value
0
1
0
Journal Near End Sensor
Disable
Enable
1
Receipt Near End Sensor
Disable
Enable
2
Journal End Sensor
Disable
Enable
3
Receipt End Sensor
Disable
Enable
4
Not defined
5
Not defined
6
Not defined
7
Not defined