CBM America CBM-262 User Manual
Page 72
7
63
(16) Specifying/Clearing underline (ESC – n)
Code: [1B] h + [2D] h + n
* (0
n
02, 30
n
32) Data are expressed in Hex code.
This command specifies or clears underlines.
•
Underlines are applied to the full width of all the characters printed, but portions
skipped with a horizontal tab (HT) or by a relative/absolute print position specifi-
cation (ESC (, ESC $), and characters which are rotated 90 degrees to the right, are
not underlined.
•
During the printing of Kanji, this underline specification/clearing command can-
not be applied.
•
The type of underline is distinguished by the value of n, as follows.
n = 0, 30: Underline is cleared.
n = 1, 31: A one dot wide underline is specified.
n = 2, 32: A two dot wide underline is specified.
•
The initial value is “n = 0”.
(17) Specifying the 1/6 inch line feed amount (ESC 2)
Code: [1B] h + [32] h
Sets the line feed amount at 1/6 inch per line.
•
The line feed amount for a set sheet selected by ESC c1 is set by this command.
Input Data Format