Dlp-e106 clean fiber connectors – Cisco 15600 User Manual
Page 6
17-6
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E106 Clean Fiber Connectors
Step 5
In the Destination area, complete the following:
•
Node—Choose the destination node.
•
Slot—Choose the destination slot.
•
Port—Choose the destination port.
•
Channel—Shown if you chose DCC Tunnel-D1-D3 as the tunnel type. Choose one of the following:
–
DCC1 (D1-D3)—Section DCC
–
DCC2 (D4-D6)—Line DCC 1
–
DCC3 (D7-D9)—Line DCC 2
–
DCC4 (D10-D12)—Line DCC 3
DCC options do not appear if they are used by the ONS 15600 (DCC1) or other tunnels.
Step 6
Click Finish.
Step 7
Put the ports that are hosting the DCC tunnel in service. See the
“DLP-E115 Change the Service State
for a Port” task on page 17-16
for instructions.
Step 8
Return to your originating procedure (NTP).
DLP-E106 Clean Fiber Connectors
Note
Replace all dust caps whenever the equipment will be unused for 30 minutes or more.
Step 1
Remove the dust cap from the fiber connector.
Step 2
To use the desktop hand tool:
a.
Advance the 3M high-performance fiber-optic wipe in the desktop hand tool to access the unused
wipe area.
Note
To replace the fiber-optic wipe in the desktop hand tool, remove the frame cover. Put a new
wipe over the base of the desktop hand tool with the stitching of the wipe aligned lengthwise
with the tool. Place the frame cover on the tool and press firmly to reattach.
Purpose
This task cleans the fiber connectors.
Tools/Equipment
Inspection microscope (suggested: Westover FBP-CIS-1)
Desktop hand tool
Scrub tool
3M high-performance fiber-optic wipes
Compressed air/duster
Prerequisite Procedures
None
Required/As Needed
Required
Onsite/Remote
Onsite
Security Level
None