Dlp-e179 repair an ip tunnel – Cisco 15600 User Manual
Page 60
17-60
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E179 Repair an IP Tunnel
Step 1
From the View menu, choose Go to Network View.
Step 2
Click the Provisioning > Overhead Circuits tabs.
Step 3
Click the overhead circuit that you want to delete.
Step 4
Click Delete.
Step 5
In the confirmation dialog box, click Yes to continue.
Step 6
Return to your originating procedure (NTP).
DLP-E179 Repair an IP Tunnel
Step 1
Obtain the original IP address of the node in question.
Step 2
From the View menu, choose Go to Network View.
Step 3
From the Tools menu, choose Overhead Circuits > Repair IP Circuits.
Step 4
Review the text in the IP Repair wizard and click Next.
Step 5
In the Node IP address area, complete the following:
•
Node—Choose the node that has a PARTIAL circuit.
•
Old IP Address—Type the node’s original IP address.
Step 6
Click Next.
Step 7
Click Finish.
Step 8
Return to your originating procedure (NTP).
Purpose
This task repairs circuits that are in the PARTIAL status as a result of node
IP address changes.
Tools/Equipment
None
Prerequisite Procedures See
Chapter 6, “Create Circuits”
for circuit creation procedures.
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher