Dlp-e186 remove pass-through connections – Cisco 15600 User Manual
Page 68
17-68
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E186 Remove Pass-through Connections
Step 6
From the File menu, choose Exit.
Step 7
In the confirmation dialog box, click Yes.
Step 8
Return to your originating procedure (NTP).
DLP-E186 Remove Pass-through Connections
Step 1
Log into the deleted node.
Step 2
In the CTC Login dialog box, check the Disable Network Discovery check box.
Step 3
Choose None from the Additional Nodes drop-down list.
Step 4
Click the Login button.
Step 5
Click the Circuits tab. All internode circuits are shown as PARTIAL.
Step 6
Refer to the diagram or CTC printout you created in the
“NTP-E169 Remove a BLSR Node” procedure
on page 13-7
or the
“NTP-E123 Remove a Path Protection Node” procedure on page 13-13
. Find the
circuits on the line cards of the removed node.
Step 7
Click the Filter button.
Step 8
Type the slot and port of a trunk card on the removed node.
Step 9
Click OK.
Step 10
In the Circuits tab, select all PARTIAL circuits that pass the filter and click the Delete button.
Note
To select more than one circuit, press the Shift key and simultaneously click on all circuits to be
deleted.
Step 11
Repeat Steps
through
for the other trunk card.
Step 12
Log out of CTC.
Step 13
Return to your originating procedure (NTP).
Purpose
This task removes pass-through connections from a node deleted from a
ring.
Tools/Equipment
None
Prerequisite Procedures
DLP-E26 Log into CTC, page 16-33
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher