Aiwa AV-D35 - Manual (Page 12)

SELECTION OF AUDIO/VIDEO
SOURCE To select the video source
1 Select one of the functions except TUNER.
2 Press the ENTER button to display VIDEO 1.
3 Turn the MULTI JOG to select VIDEO 2 or VIDEO 3.
VIDEO 1/5.1CH/BAND
1 Select the program source.
Turn the FUNCTION selector or press the TAPE MONITOR
button. The selected function indicator flashes in red.
To listen to or watch The flashing indicator
Tape TAPE MONITOR
Radio TUNER
Record PHONO
Compact disc CD
Television, etc. AUX
Video VIDEO 1/DVD/MD,
VIDEO 2/LD/TV, VIDEO 3
LD or Cable TV VIDEO 2
MDorDVD VIDEO 1/DVD/MD
To select a function on the remote control
Press the desired function button directly.
The function to be selected (except PHONO) depend on the
equipment connected to the input terminais on the rear panel
of the unit.
NOTE
When using a turntable with a built-in equalizer amplifier, set
the switch of the equalizer amplifier to off. See the instructions
of the turntable for furfher information.
2 Start the selected program source.
3 Adjust the sound.
About the video source to the monitor or TV
CF^-.
I i -i
To change a displayed name for the VIDEO
1 and VIDEO 2
When the VIDEO 1 is selected, VIDEO 1 is displayed initially. It
can be changed to DVD or MD.
Press the VIDEO 1/5.1CH/BAND button while pressing the
ENTER button.
To use the 5.1CH function, press the VIDEO 1/5.1CH/BAND
button. The function name will change to “5.1 ch IN” and the
source connected to the 5.1 INPUT terminals is selected.
To resume, press the button again so that the selected function
name is displayed.
The displayed name for VIDEO 2 button can be changed to
VIDEO 2, LD or TV; while the VIDEO 2 function is selected, press
the VIDEO 1/5.1 CH/BAND button while pressing the ENTER
button.
To adjust the sound level of the connected
source
The input sensitivity level of each function (except the TUNER
function) can be adjusted.
When the sound level of the connected source is higher or lower
than that of the TUNER, adjust it as follows.
1 Select the function to be adjusted.
Turn the MULTI JOG accordingly and play the source.
2 Press the UP or DOWN button repeatedly.
tl ARENA I .’ . '.Li2T ~ .
LaoSt arasMl
The level can be adjusted between -6dB (MIN) and +8dB (MAX)
in 2dB steps. Adjust the level so that the sound is output at the
same level as the TUNER.
' The input sensitivity level of the TUNER function cannot be
adjusted.
' That of the TAPE MONITOR cannot be adjusted either.
Even if the TAPE MONITOR is selected and the TAPE
MONITOR indicator turns red, pressing the UP or DOWN button
will change the level of the function displayed on the window.
Selected video source
VI: VIDE01, V2: VIDE02, V3: VIDE03
The selected video source is indicated on the display and the
video signal through the MONITOR VIDEO OUT jack is output
on the TV.
11
ENGLISH