Custom audio adjustment, Super t-bass system, Volume control – Aiwa AV-D35 User Manual
Page 9: To mute the sound temporarily, Sound adjustment during recording, Code
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
J
CUSTOM AUDIO ADJUSTMENT
DOWN,UP VOLUME
MUTE
VOL
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press the T-BASS button.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
arBGMi
u
(/)
z
o
i=Q
<Z
IT =3
<o
li'"
IX
IX
BALANCE
T-BASS
(cancel)
VOLUME CONTROL
Turn the VOLUME control on the unit, or press the VOL buttons
on the remote control.
The volume level is shown on the display for four seconds. It can
be adjusted between 0 and MAX (50). It flashes when being set
over the level 44.
The volume level remains memorized even after the power is
turned off. However, if the power is turned off when the volume
is set to more than 21, it is automatically set to 20 the next time
the power is turned on.
To adjust the left/right balance of the front speakers
Press the BALANCE button to display “L/R OdB”. Then press
the DOWN or UP button repeatedly within four seconds.
Note that the front speakers balance of the 5.1 CH and Dolby
Pro Logic modes is also changed.
To mute the sound temporarily
Press the MUTING button (-20 dB).
“MUTE ON” appears on the display for four seconds. While
muting the sound, the selected function indicator flashes. Press
the MUTING button again to restore the sound.
Low-frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low-frequency sound is
originally emphasized. In this case, cancel the T-BASS system.
SOUND ADJUSTMENT DURING RECORDING
The output volume and tone of the speakers or headphones may
be freely varied without affecting the level of the recording.
ENGLISH
8