What to do if... (something goes wrong?) – AEG 318V User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
What to do if... (something goes wrong?)
Faults you
... the pilot lamps do not show?
can rectify
... the oven does not heat?
yourself
1. You may weil have not operated all relevant switches or
2. The fuse in the fuse box has blown.
3.
IMPORTANT - Make sure that the oven door is closed
completely.
... the fuses keep blowing?
Please call an approved and qualified electrician:
... the oven lamp fails?
See Cleaning and care on page 32.
Replacement lamps are not covered by warranty and are
not free Of charge.
... the oven cannot be switched on?
Check whether:
... the clock display
is flashing! If yes reset the time of day.
... the audible tone of the timer
is emitting a continuous tone.
Then press the corresponding button to switch it off!
... the timer display
does not show, but the pilot lamps of the
appliance still show?
... incorrect indications
appear in the display?
... duration and end
cannot be entered!
The timer has been wrongly operated or there has been a
short power cut. Isolate the oven from the power supply
wait
30 seconds
and then switch on the power. Reset the time of
day on the electronic timer.
Please make sure that you are not able to rectify the fault
yourself prior to calling a service engineer in connection
with one of the aforementioned problems, as the cost in
volved will have to be passed on even during the warranty
period.
Therefore, follow the instructions in this booklet and any
additional information which may accompany this appli
ance carefully.
AEG electrical appliances comply with current safety reg
ulations. Repairs to these appliances should only be car
ried out by qualified AEG engineers or AEG appointed
service agents. Repairs carried out by unauthorised per
sonnel could lead to considerable damage and could pose
a considerable safety hazard to the user.
38