Alvin CraftMaster CM40-4-WB User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
r - - i f | - n - T - r , - T - p r ^ , T r - , . -
- r r - T — r j . f - y i T -
r - T T p r - f - i -
0"
1
"
2"
3"
To Adjust Tilt
The ratcheted tilt mechanisms allow you to set the table top at a variety
of comfortable working angles. Simply lift the table top from the back
edge until it clicks into the desired position. To return the top to the
flat position, raise the back edge as high as it will go. This will release
the ratchet mechanism.
To Adjust Height
It is suggested that the table height be set during initial assembly, prior
to attaching drawer units. To adjust the height at a later time, follow
these steps:
1. Please do not attempt to adjust the height with the table in the
upright position
2. It is suggested that two people perform the height adjustment to
avoid damaging table
3. Return table top to flat, horizontal position
4. Remove drawers to avoid spilling contents. (It is ok for drawer
unit frames to remain in place)
5. Carefully lay table on its back. Be sure it is resting on a caipeted
or otherwise protected surface
6. Unscrew height adjustment knob "K" from both left and right
side frames and slide out adjustment rods. Align adjustment
holes and desired setting and reinsert rods. Screw adjustment
knobs onto ends of rods and return table to upright position.
FREE GOODS -- We Welcome Your Comments and Suggestions
Alvin Drafting Dots (#DM123) work wonderfully to tape your paper and
other media to the tilted taple surface. To receive a free box of Drafting
com and submit your comments and suggestions about our CraftMaster
table. We are constantly working on product improvements and look
forward to hearing from you.
Page 10