Alvin CraftMaster CM40-4-WB User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I I I ■ H I |-r|-rrT-r ■ ■ I • I • j 1 • I . 1 I I M ' ' I ■ I I ' I ' I ' I I
0
"
I"
2"
3'
15. Carefully turn base assembly upside down and place on table
top (this may require two people ) Be sure that the two
threaded inserts near the back edge of the table top align with
the attachment holes in the tilt mechanisms "I" and the base is
centered left-to-right. The upper cross bar-large "F” should be
positioned between the 2 sets of pre-drilled holes.
16. Align table top brackets "M" with the 2 sets of pre-drilled
holes. These brackets should straddle and capture the upper
cross bar "F". Attach brackets using 5/8" phillips screws "R".
17. Attach tilt mechanisms "I" to tabletop using 1/2" alien bolts
"Q".
18. Carefully return assembled table to its upright position (this
may require two people).
Pa^e 8