Figure 5, Pencil tray – Alvin CraftMaster CM40-4-WB User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
M I ^ I ' I ' -г-n-p^—p-: I J I I ' I > ' I ' I ' I I ' I ' ' I ' I IJ I ' I ' I I
0
"
I"
2"
3'
13. Place table top "A" on a caipeted or otherwise protected floor,
to avoid scratches, with the pre-drilled holes facing up.
14. Choose either the pencil ledge "U" or pencil tray "V" ( not
both ) and attach using 5/8” Phillips screws "R” into pre-drilled
holes in front of tabletop. If attaching metal pencil ledge,
folded-over edge should be on the underside ( unfinished side )
of tabletop and should point towards back edge of board.
Figure 5
Pencil Tray
Advertising
This manual is related to the following products: