Bulldog Security DELUXE 500 - Manual (Page 11)

REMOTE START OPERATION OPERATION
I. SHl/T-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exists while the system Is operating, the
engine will not start or will shut down Immediately:
1. The ■ ■
' ■ pressf
3. The emergiency brake is released (for Standard Transmission Vehicle)
he hood is opened.
2. The brake pedal Is iressed.
4. Engine is over-rewed. -CTachometer checking type' only}
5. The pre-programmed run time [5 /10 / 2 0 / 3 0 minutes) has elapsed.
6. Pressing
V button twice on the remote transmitter.
7. Move the optional remote start enable toggle switch to 'DFP" position.
^ Installed)
8. If the engine does not start with {3} attempts.
3. DISABLING THE REMOTE START SYSTEM: (If Installed]
This feature allows your system's remote starter to be temporarily disabled
to prevent the vehicle from being remote started accidentally. This feature
Is useful If the vehicle Is being serviced or stored In an enclosed area. To
disable the remote starter, move the optional remote start enable toggle
switch to the 'VFP* position.
rrt PClirifTC TP*MCrCTlfCD
ir/aesr
, 0 ^ GN i
Note: ttieswtein may be Interfared with by stroiMer radio ^
of high voltage electric power lines or omacies such ae —
maiy be shorten due I d the systems
Aigh voltage electric power linea or ol
________ Jw Iraiwmbslon ratige maiy bi
use of a low powered output frequency
0. PANIC MODE:
The transmitter can be used as a remote panic switch to
manually trigger the alarm in case emergency.
1. Press and hold the fl
button for 3 second. The alarm will
immediately sound.
2. During "Panic Mode", the normal function of this trans­
mitter button will be suspended. The B and i buttons can be
used to lock and unlock the doors (If the option Is Installed], however
once the B button is pressed, the vehicle's starter disable
device, (if installed) will be enable allowing the vehicle to start.
3. To stop the "Panic Mode", press and hold the B or B buttons on the
transmitter again fdr 3 seconds, if any transmitter button other than the
fi or B
button Is pressed and released, the "Panic Mode" will be turned
off immediately.
4. If the button is not pressed, the alarm will automatically stop after 30
seconds.
P. SYSTEM'S STATUS CHECK
When you want to check the system's present status through
the LCD screen. Press the transceiver
F button (2) times,
within 3 seconds press the [ Q ) button. It responds with
one melody sound, the LCD screen should be illuminated.
Note:Ifthi ere Is no responoe then you are out of range.
18
Q. DOME IIGHT SUPERVISION
The alarm has a unique feature that will turn "ON” your vehicles dome light
as follows;
1. Upon disarming, the interior dome light will remain "ON" for 30 seconds.
2. If the vehicle Is Intruded, the Interior dome light will flash for the same
duration as the siren.
Note: Turning on the ignition switch or arming the aiarm wiii turn
off the domelight.
R. IGNITION CONTROLLED DOOR LOCK/UNLOCK.
If the vehicles door locks have been Interfaced to the security systems
keyless entry, the system will automatically lock the vehicle's doors when
the ignition is turned "ON" and will unlock the vehicle's doors when the
Ignition Is turned "OFF”.
11