Bulldog Security DELUXE 500 - Manual (Page 12)

OPERATION REMOTE START OPERATION
S. TRUNK RELEASE (CHANNEL 3) OUTPUT.
Press snd hold the ^ button on the transmitter for two sec­
onds to remote control the tnink release or other connected
electronic devices.
T. CHANNEL 4 TIMER CONTROL OUTPUT
Press the transmitters fl (4) and ^ (4) buttons at the
same time to active the Channel 4 funcnon. Channel 4 is user-programmable
timer output. You may program the bullt-ln timer to send a ground signal
for any time duration mom f second to 120 seconds. For Instance,
this timer output may be used to turn on the headlights, power
windows or sunroof. [Factniy defaults setting at momentary
output.)
U. CHANNEL 5 HMER CONTROL OUTPUT
Press the transmitters 3 [n and ^ (5) buttons at the same dme to
active the Channel 5 ftmctlon. Channel 5 Is user-programmable timer
output. You may program the built-in timer to send a ground
signal for any time duration from 1 second to 12D seconds.
For instance, this timer output may be used to turn on the
headlights, power windows or sunroof. (Factory detaults
setting at monMntary output.)
V. CHANNEL 6 TIMER CONTROL OUTPUT
Press the transmitters (6) it and (6) ^buttons at the same time to active
Channel 6 function. Channel 6 is user-programmable timer output. Ybu may
program the bullt-ln timer to send a ground signal for any time
dur^on from 1 second bo 120 seconw. For Instance, this timer
output may be used to turn on the headlights, power windows
or sunroof.
(Factory defbuRs sotting at momontary output)
12
Exit tho tlnior start:
1. Timer start can be esdted manually as fbllovirs:
Make sure the engine is not running in remote start mode.
2. Turn the ignition Hey ON. The LED and parking lights will flash (4) times.
The hom chirps (4) times.
Or
1. Press the ^ button twice to remote start the vehicle. As soon as the
vehicle Is running and the parking light have turned on or are flashing.
2.Immediately d»res5 the ^ button, then press and hold the % button
for 2 seconds. The parking lights will flash (4) times. The siren or hom
chirps (4) times. The vehicle Is no longer programmed to start automatically.
G. INTERIOR TEMPERATURE MONITOR
You can monitor through the LCD screen, the present interior
temperature of the passenger compartment before cooling or
heating your vehicle. Press the transceiver
F button first,
within 3 seconds press the ^ (h button; the interior temp­
erature will be shown on the IXD soeen. This reading may be
higher than actual ambient temperature due to the greenhouse
elrect and Is relative only the Inside vehicle temperature.
H. TO TURN OFF THE REMOTE STARTS
When the engine Is running [In remote start mode), to shut the
engine off: Press the ^
button twice on the remote transmitter.
Move the optional remote start enable toggle switch to the
"OFF’' position. (If Installed) Press the brake pedal. Release the
emergency brake, (for Standard Ttansmlssfon Vehicle} The
vehicle win shut down and turn off the parking lights to Indicate
engine has stopped.
17