Bulldog Security DELUXE 500 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ШШ

impar

feature Is design for an extreme cold climate usage. Tfie system will

automatically start the vehicle every 2 or 3 hours, to prevent the engine

from freezing and to prevent a vehicle from being hard to start.
A MAXIMUM OF SIX <^LES CAN OCCUR.

2 lo 3 hour timer start with Temperature-control:

If you programmed the

temperature ON

to operate. The system can be

programmed to automatically start the vehicles engine whenever the

temperature Inside the vehicle reaches or drops below the preprogrammed
temperature level. The system will monitor the air temperature every 2 to

3 hours and will only start the engine during extreme cold temperatures.

There are C3} three temperature levels to choose from.

Daily Timor start:

This feature is very useful for the driver who wants to

run the vehicle punctually at the same time the next morning. Before setting
up the

"Dally Timor Start",

you should set you time for engine start, f

see

Timor Sotting / Timor и^ир fbr "Dally Timer Start, page 16]

To ENTER:

L. Press the ’(t

button

twice to remote start the vehicle. As soon as the

vehicle Is running the parking lights will turn on or start flashing.

2.1mmed1ately depress the ^

button

once, within 2 seconds.

3-a. Z to Э Hour Timor Start:

Rapidly depresses the ^

button.

The

parking light will flash [3] times. The siren or horn chirps (3) times. The

vehicle is now programmed to start every 2 to 3 hours.

3-b. Dally Timer Start

Depress the transceiver

F button

first, within 3 seconds press ^ (O) button. The parking

lights will flash (6) times. The siren chirps [6] times. The

vehicle is now prc^rammed to start at this set time, the

next day. Your set time fbr the next da^the engine start

flashes for approx. 3 seconds on the LCD screen. After 3
seconds the О Icon stays displayed on the LCD screen.

4.

Press the brake pedal to shut the engine off.

A. TO REMOTE START THE VEHICLE

When you want to Remote Start your vehide.

Activate

Rorrtobe

Start

Engine

Running

1.

Press the

button

twice on the transmitter

2. The parking light will flash bo Indicate the remote starter

received the signal. (A melody sounding from your Remote
LCD transceiver and the"^' Icon will flash on the LCD screen

to confirm the remote starter was activated.)

3.

The engine will start In approximately 5 seconds.

4.

Once the engine Is running, after couple seconds the parking

light will turn

on

and climate controls will activate and adjust

the vehicles Interior temperature to your preset setting.

S

While the vehicle Is running, the

icon and the ''minutes'

igit on the LCD screen will nash and it will Indicate a count

down timer based on the 5 , 1 0 , 2 0 or 30 minute run time

pu have selected]

5.

the vehicle will run for 5 to 30 minutes and automatically

shut down. (When the unit shuts Off the count down timer

will turn off and the transmitter will play a melody.)

NOTE: The

Remote Start Unit will not start the vehide If any

one of the followingconditions exists:

1.

The hood is opened.

2.

The brake pedal Is pressed.

3.

Move the optional remote start enable toggle switch to

"OFF"

(Ifinstall«r)

4.

The gear selector is in any gear other then "PARK* or ’NEUTRAL’

S.

The e-brake Is not set. [for №ndard Ttansmisslon Vehicle)

SAFE START (Child safrty mode]

(Factory defaults setting] press the

m button

twice on the transmitter to

start the vehide. Pmgramming this feature will eliminate an accidental

remote start, when Idas enter this transrinltter. It enquires:

The user presses the transmitters

Q

and ¥

buttons

at the same time to

remote start the vehide.

position.

16

13

Advertising