Chamberlain 3800P - Manual (Page 28)

28
*3-Button Remote
If provided with your garage door opener, the large button is
factory programmed to operate it. Additional buttons on any
Security
✚
®
3-Button remote or
mini-remote can be
programmed to
operate other
Security
✚
® garage
door openers.
To Erase All Codes From
Motor Unit Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the “learn” button on
motor unit until the learn indicator light
goes out (approximately 6-9 seconds).
All previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door
will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security
✚
® remote controls.
1. Press and release the purple “learn”
button on the motor unit. The learn
indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON USING THE SMART CONTROL PANEL™
LOCK LIGHT
PROGRAMMING
NOTICE: If this Security
✚
® garage door opener is operated with a non-rolling code transmitter, the technical measure in the
receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the
copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to
circumvent that technical measure.
LOC K LIGHT
LOCK LIGHT
LOC K LIGH T
1. Press the Prog <Learn> button on the
Smart Control Panel™.
2. Press the Prog <Learn> button again
to confirm Learn Mode.
3. Press the button on the hand-held
remote that you wish to operate your
garage door.
4. When the motor unit lights blink, it has
learned the code. If light bulbs are not
installed, two clicks will be heard.
LOCK
LIGH T
LOCK
LIGH T