Aiwa NSX-V2100 - Manual (Page 14)

SETTING THE TIMER
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly. (See page 4.)
1 Press the TIMER button on the remote control
while pressing the SHIFT button once to display
©, and press the 11 SET button within 4 seconds.
© is displayed, and the hour flashes.
0
' ' IV/( I I I •
I I S
If you do not press the 11 SET button within 4 seconds, another
operation may start.
2 Designate the hour of the timer-on time by
pressing the DOWN or UP button, and
the 11 SET button. Repeat to designate the minute
of the timer-on time.
■ I I l\// i„ i.j • ■■
After you designate the timer-on time, TIMER and one of the
source name flashes alternately on the display for 4 seconds.
3 Within 4 seconds, press one of the function
buttons to select a source.
“TIMER” and the selected source name flash alternately for
4 seconds.
• If this step is not completed within 4 seconds, repeat from
step 1.
• If the TUN ER button is pressed, the band cannot be selected
in this step.
4 Within 4 seconds, select the duration for the
timer-activated period with the DOWN or ►M
UP button.
i
f t r h '
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
• If this step is not completed within 4 seconds, repeat from
step 1.
5 Prepare the source.
To listen to a CD, load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
6 Press the POWER button to turn the unit off after
adjusting the volume and tone.
0 remains on the display after the power is turned off (timer
standby mode).
7 Get ready for the TAPE function or the timer
recording.
To listen to the tape, press the ► button.
To record the source, press the • button on deck 1.
When the timer-on time is reached, the unit turns on and
begins play with the selected source. While the timer is in
operation, the display indication is dimmer than usual.
The timer recording period and tape length
When the length of the tape to be recorded is shorter than the
timer recording period, the # button on deck 1 is released before
the timer is off.
When the tape length is longer than the timer recording period,
the • button is not released. If the • is not released for a long
time, the tape in the deck may be damaged. Press the M / ±
button to release the # button.
To cancel the timer standby mode temporarily
While pressing the SHIFT button, press the TIMER button so
that © goes out in the display.
To restore the timer standby mode, press the TIMER button while
pressing the SHIFT button to display 0.
If using the unit after setting the timer
After setting the timer, you can use the unit. After using the unit,
check whether the contents in steps 5 and 6 are set as you wish,
turn off the power and set step 7 if necessary.
To change the specified time and function
Repeat all the steps again.
To check the specified contents
While pressing the SHIFT button, press the TIMER button. The
timer-on time is displayed for 4 seconds.
* Timer playback and timer recording will not begin unless the
power is turned off.
• Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
13
ENGLISH