Iv. normal operation - step-by-step, Important, Caution – Blodgett S1820G User Manual
Page 30: Normal operation - step-by-step, Conveyor, 5< fiti a
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
IV. NORMAL OPERATION - STEP-BY-STEP
A.Daily Startup Procedure
SECTION 3
OPERATION
1. Check that the circuit breaker/fused disconnect is in the
on position.
2.
Turn
the
"BLOWER/
HEATER" (C03) switch
to the “ON" ("[") posi
tion.
3.
BLOWER/HEATER
Adjust the temperature
controller to a desired set
temperature, if neces
sary.
•
Press the Set Point fi/ti-
and Unlock keys at
the same time. Wait
forthe"SETPT"iight
to turn on.
•
Press the Up Arrow
and Down Arrow
Keys as necessary
to adjust the set-
Or
point.
.
Q>£<icn
4. Turn the "CONVEYOR"
<i^) switch to the "ON"
("i") position, and wait for
the "HEAT ON’Mighttoturn
on.
wait for
Temperature
Display before
Wring switch to
“ON''position.
CONVEYOR
1
fi-h A V
y
5. if necessary, adjust the
conveyor speed setting
by pressing the /\or\7
pushbuttons on the con
veyor speed controller to
change
the
displayed
bake time.
6. Wait for the oven to heat to the setpoint temperature.
Higher setpoint temperatures will require a ionger wait.
The oven can reach a temperature of 500°F (232°C) in
approximately 15 minutes.
7.
(Optional)
Press the Tem-
perature (|) key to show
the Actual Temperature
in the display, and wait
for the "ACTUAL TEMP"
light to turn on. This al
lows you to monitor the
oven temperature as it
rises to the setpoint.
^Fsoo
5<
fiti A ▼
y
wait
for
t ACTUAL
■ THMP
8. Allow the oven to preheat for 10 minutes after it has
reached the set point temperature.
B. DAILYSHUTDOWNPROCEDURE
1.
Turn
the
"BLOWER/
HEATER" (c§j) switch to
the "OFF" ("O") position.
Note that the blowers wiii
remain in operation until
the oven has cooled to
below 200T (93°C).
^ BLOWER/HEATER
2. Make certain that there
are no products left on
the
conveyor
inside
the
oven.
Turn
the
"CONVEYOR"
switch to the "OFF" ("O")
position.
CONVEYOR
3. After the oven has cooled and the blowers have turned
to the “OFF” or“0” position, switch the circuit breaker/fuse
disconnect to the “OFF” or "O" position.
IMPORTANT
On gas ovens. If the "HEAT ON" light will not illuminate,
OR if the oven does not heat, the gas burner may not have
lit. Turn the "CONVEYOR"
and "BLOWER/
HEATER" (C05) switches to the "OFF" ("O") position. Wait
for AT LEAST FIVE MINUTES before restarting the oven.
Then, repeat the Daily Startup procedure.
CAUTION
In case of power failure, turn all switches to the “OFF”
("O") position and remove the product. After the
power has been restored, perform the normal startup
procedure.
IFTHEOVENWASSWiTCHEDOFFFOR
LESS THAN 5 MINUTES, WAIT FOR AT LEAST FIVE
MINUTES BEFORE RESTARTING THE OVEN.
24