H. attaching drive chain – Blodgett S1820G User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. Reconnect the inside master links (Figure 4-29.)
SECTION 4
MAINTENANCE
H. Attaching Drive Chain
I. If drive sprocket assembly was removed reassemble it
into the conveyor drive shaft. Be sure fiat on end of drive
shaft aligns with set screw in conveyor shaft collar. Once
in place tighten 3/32" set screw.
2. Lift conveyor and instali drive chain to conveyor drive
sprocket and motor sprocket.
Figure 4-29.
NOTE: The outside master links have right and left sides
to them. The right edge master link has an open hook
facin g you as shown i n Fi g u re 4-30. Th is wil I match up with
the outer edges of the conveyor belt. Remember this hook
travels backwards on the conveyor.
3. The angle plate located on the underside of the con
veyor must be against the lower end plug. This is true on
both sides of oven.
Figure 4-30.
7. Reconnect the outside master links.
8. Replace all parts removed from the oven.
38