AEG 155 D User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Clean the inner housing using a hot detergent solution only
(never use caustic detergents, abrasive powders or brushes).
3. Leave the metal grease filter panel to soak for approximately 1
hour in very hot water with grease-dissolving detergent and
then rinse it with very hot water. Repeat the operation if
necessary. Load the grease filter panel in a dishwasher,
selecting the most intensive washing programme and maxi
mum temperature, at least 65°C. Repeat the operation if
necessary.
4. When both metal grease filters have been cleaned and left to
dry, replace them by following the above operations in reverse
order (front first and then back).
5. Screw the fuses back in or reset the automatic circuit breaker.
6. Proceed as follows to reset the filter saturation display (coun
ter). Select any fan speed using my E or F buttons and
then press my [
q
] B and F buttons at the same time,
continuing to hold them down for at least 3 seconds until the
flashing letter F stops being shown on the display (D) and then
press the button B.
39