Introduction – AEG 155 D User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Introduction
The hood is supplied as an extractor unit and can also be used
with a filtering function by fitting activated carbon filters (special
accessory).
The unit features two outlet holes, one of which A is located on the
top of the unit while the other B is located on the rear.
To connect up the hose, you should first fit the bayonet-mounting
flange C on the outlet required (if using the top outlet, fix the flange
in place using the screw supplied as shown in Fig, 1.
Close off the unused hole using the bayonet-fitting caps D.
If using the rear hole, open the air passage by removing the
partition (E — Fig. 2)
Move the lever F to position A — Fig. 3.
When connecting up the hood using a telescopic wall pipe,
you should preferably using the uninflammable outlet hose
No. E 610 899 007 (120 mm 0) from our range of special
accessories.
Extractor
version
23