A&D Journal Printer AD-8118A - Manual (Page 12)

Replacing the Printing Paper
I---- 1
o 0
Front View
1, First, turn the power OFF.
2 .
r
3.
Side View
Side View
Front of Printer
j] Paper Roli
4.
5.
oi.
Side of Printer
6 .
Loosen the screws on the printer cover and
draw out the printer unit.
Peel off the adhesive tape on the printing
paper (PP-137) completely, insert the shaft
provided as an accessory and set the
paper. (Be careful of the Erection of the
paper.)
After setting the paper to the holder, take
out the paper and insert it into the opening
labeled "A" on the printer through the lower
side of the roller, as shown to the left.
With the paper inserted, turn the right knob
of the printer unit in the direction of the
arrow shown to the left; the paper should
come out the front.
!f the paper fails to come out, check for a
bend or fold in the paper. If it is difficult to
insert, fold the top over a few centimeters.
If the ink ribbon needs adjusting turn the
knob of the ink ribbon to give tension to it.
Return the unit to its original position and tighten the screws on the
printer cover.
Note 1: Do not apply excessive force to the printer unit. If normal, it
can be drawn out easily. If it is hard to take out return it once and draw
it out again. The guide may be damaged if excessive force is applied
vertically or horizontally.
Note 2: The printer is made of precision components and could be
damaged if metallic powder, water or other foreign substance get inside
the printer. Also be careful of static electricity when the printer is drawn
out..
If dust and other foreign substance get inside the unit, blow it out with
clean air. If the unit is used in a dusty environment consider using a
dust cover or air purge when not in use.
Note 3: A red mark will be printed approximately 1m before the end
of the roll of paper; replace the paper when you see this mark.
owners-AD-8118A-v.3.a Page 11