A&D Journal Printer AD-8118A - Manual (Page 28)

* 2 A unit with ”(OP-xx)" can connect to the standard serial output.
Please set the DIP switches according to the specifications of these units.
When connecting to an AD-4325A, cumulative total can be started by the
codes of the AD-4325A if set to the output of format with the correct code.
Set the printer mode on DIP switch #3 to standard format.
AD-4601 has RS-232C. Set print mode of RS-232C Function . you can
input standard format data. (The flow speed can't be input; In this case ,set
dump printing mode.) >
Connection to an Electronic Balance
The standard format of A&D's electronic balances are as follows:
EP series + OP-03
ER series + OP-03
ET series
■
+ OP-03
FX series + OP-03
FY series + OP-03
FC series + OP-03
EK series + OP-03
FR series + о P-03
Set the DIP switches according to their specifications.
Connection to Peripheral Devices
This unit has the functional ability to send outputs, as well as input data,
through the current loop. This allows connection to the AD-8916, AD-8917,
AD-8918, AD-8117 and AD-8118A.
For example, if two AD-8917's are connected, the setting of gross weight,
net weight and tare weight output through the serial output of an AD-4322A,
AD-4323 or AD-4325A can be achieved. The following application will then
be realized:
AD-4323, etc. AD-8118A
in the above example, the gross weight is displayed in the AD-8917 "A" and
the tare in the AD-8917 "B". Then the net weight data is printed on the
AD-8118A and the cumulative total is calculated. Note that this printer can't
be connected to more than two other units.
owners-AD-8118A-v.3.a Page 27