Beko OIM 22301 X - Manual (Page 12)

Connection to the mains supply
CD
Important
This appiiance must be earthed!
Our company shall not held
responsible for any damage
caused by using the appliance
without earthed socket.
DANGER
Risk of eiectric shock, short
circuit or fire by unprofessional
installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and the
appliance is only guaranteed after
correct installation.
DANGER
Risk of eiectric shock, short
circuit or fire by damage of the
mains lead!
The mains lead must not be
clamped, bent or trapped or come
into contact with hot parts of the
appliance.
If the mains lead is damaged, it
must be replaced by a qualified
electrician.
The mains supply must correspond to
the data specified on the type plate of
the appliance. The type plate can be
seen when the front door is opened.
The appliance mains cable must
correspond to the specifications and
the power consumption; see Technical
Data, page 5.
DANGER
Risk of electric shock!
Before starting any work on the
electrical installation, please
disconnect the appliance from the
mains supply.
1. If no all-pole separation from the mains
supply is possible, a separation unit
must be connected with a contact
distance of 3 mm min. (fuses, line
safety switches, contactors) all poles
which should be adjacent to (but not
above) the cooker in accordance with
lEE regulations. Failure to observe this
instruction may result in operational
problems and invalidation of the
appliance warranty.
Additional protection by a residual current
circuit breaker is recommended.
If a cable without a plug is provided
together with your appliance;
for mono-phase connection, take
care to connect as below:
Brown cable = L (Phase)
Blue cable = N (Neutral)
Green/yellow cable must be
connected to ground (E) line.
12 I EN