Arcam CR80 - Manual (Page 5)

SEARCHING FOR YOUR CODE LEARNING A FUNCTION
If your device does not respond to the ARCAM CR80 after trying all codes
listed for your brand, or if your brand is not listed at all, try searching for
your code,
For example, to search for a code for your TV:
1 On the ARCAM CR80, press TV once.
2 Press and hold SET until the LED blinks twice, then release SET,
3 Enter 9 - 9 - 1 . The LED will blink twice.
4 Aim the remote control at the TV and slowly alternate between
pressing PWR and TV. Stop when the TV turns off.
NOTE: In the search mode, the ARCAM CR80 will send IR codes from its
library to the selected device, starting with the most popular code first
5 Press SET once to lock in the code.
6 To search for the codes of your other components, repeat steps 1
through 5, but substitute the appropriate key (i.e„ CBL, DVD, VCR,
TV, SAT, CD, or AUX) for the <Cable, VCR, Satellite, CD or Tuner)
component you are searching for.
NOTE: This feature is not applicable for the AMP key because it has only
one dedicated code in this mode which controls the Arcam AVR200,
AVR 100 and AV8.
CAUTION
Do not the reset commands for other Universal Electronics
remote controls on the CR80. Resets will permanently delete
key functions in the lower section of the remote, and the
warranty on this remote control will be invalidated.
The ARCAM CR80 can be setup to learn a function from an original remote.
To optimize success, the learning feature should be conducted in an area
where there is a low level of IR emission. High levels of "natural light" or
energy efficient fluorescent lights could interfere with a learning event.
Example: To learn the "mono/stereo" function from your original TV
remote control onto the MODE(GUIDE)-key of your ARCAM CR80.
1 Place the ARCAM CR80 and your original remote control on a
flat surface. Make sure the ends which you normally point at
your device are facing each other. Keep the remotes at a
distance of 1 to 2 inches (2 to 5 cm).
2 On the ARCAM CR80; Press and hold the SET key until the LED
blinks twice. The LED will blink once then twice.
3 Press 9 - 7 - 5 (the LED blinks twice).
4 Press the device key on the ARCAM CR80 remote to select the
mode to which you want to copy the learned function (Example:
TV key).
5 Press the key on the ARCAM CR80 remote where you want to place
the learned function (Example: MODE<GUIDE)-key). The LED will
flash rapidly.
6 Press and hold the key (on your original remote control) that you
want to copy until the LED blinks twice (Example: mono/stereo
key).
7 If you want to copy other functions within the same mode, simply
repeat steps 5 until 7 pressing the next key you want to copy by
learning (up to limit of memory).
8 To exit the learning mode, press and hold the SET key until
the LEO blinks twice.
9 To access a learned function, press SET then press the
appropriate key,
Deleting a learned function:
To delete a learned function, either overwrite it with a new function on
the same key. or use the following sequence:
1 On the ARCAM CR80; Press and hold the SET key until the LED
blinks twice, The LED will blink once then twice.
2 Press 9 - 7 - 6 (the LED blinks twice).
3 Press the device key on the ARCAM CR80 remote to select the
mode to which you want to copy the learned function (Example:
TV key).
4 Press the key to be deleted.
5 Again, press the key to be deleted.The LED will blink twice.