Arcam CR80 - Manual (Page 7)

TROUBLE SHOOTING
PROBLEM: LED does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA alkaline batteries. .
PROBLEM: LED blinks when you press a key, but home entertainment com­
ponent does not respond.
SOLUTION: Make sure the ARCAM CR80 is aimed at your home entertain­
ment component and is not farther than 15 feet away.
PROBLEM: ARCAM CR80 does not control home entertainment components
or commands are not working properly
SOLUTION:Try all listed codes for the component brands being set up.
Make sure they can be operated with an infrared remote
control.
PROBLEM: No volume on a 2nd TV.
SOLUTION: Follow instructions In Changing Volume Lock.
PROBLEM: CH+ , CH-, and LAST do not work for your RCA TV.
SOLUTION: Due to RCA design (1983-1987), only the original remote control
will operate these functions.
PROBLEM; Changing channels does not work properly.
SOLUTION: If original remote control required pressing ENTER to change
channels, press ENTER on the ARCAM CR80 after entering the
channel number.
PROBLEM: Tried "Search Method" and stilt could not find a working code.
SOLUTION: Try the "Search Method" again after clearing out the device key
as follows: Press and hold SET until red light blinks twice, then
release, Next enter 9 - 9 - 2 . Then press and release the device
key to be cleared twice.
12